Operation Manual

Operation
Operating Instructions 841 - 00.0 - 09/2014
31
• Area under hook
• Bobbin housing
• Thread cutter
Cleaning steps
1. Remove any dust and thread remains using a compressed air gun or a
brush.
2. Clean the vacuum pump (additional equipment).
5.12.2 Lubrication
Required oil:
Only DA 10 or equivalent oil should be used for the machine, which has
the following properties:
• Viscosity at 40 °C: 10 mm²/s – ISO VG10
• Flash point: 150 °C
WARNING
Risk of injuries due to contact with oil.
Contact with oil can cause irritation, rashes, aller-
gies or skin injuries.
ALWAYS avoid long-term contact with oil.
ALWAYS thoroughly wash the affected areas if
contact with oil occurs.
ATTENTION
Machine damage possible due to incorrect oil.
An incorrect oil type can cause damage to the machine.
Only use oil that complies with the data in the manual.
Risk of environmental damage from oil.
Oil is a pollutant and must not enter the sewage
system or the soil.
Carefully collect waste oil and dispose of the waste
oil and oil-contaminated machine parts in the legal-
ly prescribed manner.
ATTENTION