Operation Manual

Operation

Operating Instructions 841 - 00.0 - 09/2014

5.11.6 Removing the sewing material from the stacker

1. Press the key.

 Stacker opens.

2. Remove the sewing material.

3. Press the key.

 Stacker closes.

5.11.7 Working with dongle data

Buttonhole data, sequence data and machine data can be loaded using a

data dongle and stored. For more information see  Service manual.

5.12 Maintenance

This section describes simple maintenance work that needs to be carried

out on a regular basis. This maintenance work can be carried out by the

operating personnel.

5.12.1 Cleaning

Lint and thread remnants should be removed after every 8 hours of oper-

ation using a compressed air gun or a brush. In the case of very fluffy ma-

terial to be sewn, the machine must be cleaned more frequently.

Points that need to be cleaned particularly thoroughly:

• Underside of throat plate

• Sewing basket

WARNING

Risk of injury

Switch off the machine at the main power switch be-

fore cleaning the machine.

Flying particles can get in the eyes, causing injury.

Hold the compressed-air pistol so that particles do

not fly toward persons.

Make sure no particles fly into the oil pan.

ATTENTION

Damage to the paintwork due to solvent-based cleaners.

Solvent-based cleaners will damage paintwork.

Only use solvent-free substances for cleaning.