Operation Manual

Operation
Operating Instructions 841 - 00.0 - 09/2014
29
• Press the OK key.
• Remove the material to be sewn
• Press the key if sewing material is not to be reinserted.
• Confirm sewing over, cf. Step 1.
Jumping from buttonhole to buttonhole (mode B)
1. Press the Safe Stop key.
2. Insert the needle thread, see ( 5.2 Threading in the needle thread,
page 20).
3. Release the Safe Stop key.
4. Using the buttons, jump from buttonhole to buttonhole.
5. Press the OK key to start the sewing process.
6. Press the ESC key to cancel the sewing process.
 Sewing material is de-stacked.
Continuing sewing (C mode)
Sewing of the buttonhole will continue after the detected thread break.
1. Press the Safe Stop key.
2. Insert the needle thread, see ( 5.2 Threading in the needle thread,
page 20).
3. Release the Safe Stop key.
 Sewing basket moves with the material to the detected thread break
point.
4. Using the keys, move towards the position where sewing is to be con-
tinued.
5. Press the OK key.
 Sewing process starts.
6. Press the ESC key to cancel the sewing process.
 Sewing material is de-stacked.
5.11.5 Sewing material inspection indicator
Depending on the material and button distance, the light barrier may show
the message Correct sewing material inspection?.
1. Check the sewing material.
2. Press the key to correct the sewing material.
 The Remove sewing material message is shown.
• Press the OK key. Remove the sewing material.
3. Press the key to continue sewing without any adjustment.
• Press the OK key.