Operation Manual

Operation
28
Operating Instructions 841 - 00.0 - 09/2014
5.11.2 Checking the buttonhole setting
1. Use the buttons to select the index program.
2. Press the F key once to switch to manual sewing mode and sew a
buttonhole or to check the settings for the current buttonhole.
3. Insert the material to be sewn.
4. When sewing the first buttonhole: Hold the end of the thread.
5. Press the S key.
 Sewing process starts.
6. Check the buttonhole settings and adjust if necessary.
5.11.3 Sewing the buttonhole placket
1. Place the sewing material at the infeed unit limit stop and at the marking.
2. Press the knee button.
 Sewing process starts.
3. Insert more sewing material.
4. Press the knee button.
 The sewing process starts automatically as soon as the first sewing
process is completed.
5.11.4 Continuing to sew after a thread break
After detecting a thread break, the machine is stopped. The cutter is
switched off, the needle moved up, the sewing basket remains lowered.
 The thread break message is shown.
1. Press the Safe Stop key.
2. Thread in the hook thread or needle thread and check this.
 There are 3 ways to continue sewing after a thread break. This is set
at technician level.
To do this read the  service instructions or follow the instructions on
the control panel.
Stitching over (mode A)
The buttonhole is entirely sewn over.
1. Press the key to confirm stitching over.
• Press the Safe Stop key.
• Insert the needle thread, see ( 5.2 Threading in the needle thread,
page 20).
• Release the Safe Stop key.
• Press the OK key.
2. Press the key if sewing over is not required.
 The Reinsert message is shown.
• Press the key if sewing material is to be reinserted.
The buttonhole will needs to be opened up and resewn.