Operation Manual

2.3 Tilting the machine head up

For maintenance work the machine head can be tilted up.

For this purpose the transport carriage must be in its rear end position.

Caution: Danger of injury!

Switch the main switch off.

Tilting the machine head up.

–

Remove the covering hood 1.

For this purpose lift the covering hood at the front so that the catch

is released. Carefully lift the covering hood upwards.

–

Swing the folding station 3 out by 90°.

–

Swivel the locking lever 4 up.

–

Lift the left fabric sliding sheet 6 at the front and swing it to the left.

–

Remove the right fabric sliding sheet 7

(see Operating Instructions, chapter 2.2.)

–

Lift the machine head in the area of head cover 5 and tilt it up

carefully.

Pawl 2 snaps in additionally.

The space under the machine table is accessible for cleaning now.

Caution: Danger of injury !

Do not reach into the table top cutout when the machine head is tilted

up.

Swinging the machine head back

–

Hold the machine head tight in the area of head cover 5.

–

Release the pawl 2.

–

Swing the machine head back carefully.

Caution: Danger of breakage!

Hold the machine head tight until it is at rest completely.

–

Insert the fabric sliding sheets.

–

Swivel the locking lever 4 down.

–

Swing the folding station 3 back and let it catch with the locking

lever.

–

Put on the covering hood 1 and let it catch again.