Operation Manual

2.2 Turning On - Quick Stop - Restarting
Caution Risk of Injury !
Do not reach into the area of moving machine parts.
Turning on
–
Turn the main switch 2 on.
The controls are initialized.
The sewing unit requests a reference run.
–
Press the "
Σ
" key.
The reference run is conducted.
The sewing unit is operational.
Turning off
–
Turn the main switch 2 off.
The sewing unit is separated from the power supply.
It is
not
operational.
Quick stop
To immediately stop the sewing unit by operating errors, needle
breakage, thread breakage, etc. the "
STOP
" key on the controls 1
must be pressed.
–
Press the "
STOP
" key.
All running procedures of the sewing unit are immediately stopped!
The sewing unit is returned to the same status which it is in after
being turned on.
Restarting
ATTENTION !
The restarting of the sewing unit after a quick stop may only occur
after the corresponding malfunction has been corrected.
–
Turn main switch 2 off.
–
Correct the malfunction.
–
Turn main switch 2 on.
The sewing unit is ready to start again.
12
6