Operation Manual

3. Setting the Controls
The setting of the controls is explained in detail in Part 4:
Short Description Microcontrol !
Here only those settings required for the sewing sequence are listed.
Caution Risk of Injury !
Turn the main switch on !
The programming of the controls occurs with the main switch turned
on!
The machine should not be started unintentionally.
–
Set the
" Program "
switch to 10 to 29.
The sewing program is selected.
10 - 29
= Sewing program for darts and pleats
–
–
Press the
" STOP "
key.
The sewing program is activated.
The sewing unit requests a reference run.
–
Press the "
Σ
" key.
The reference run is conducted.
–
Only for program writing or program alteration !
Press the "
P
" key for 3 seconds.
The controls change to the
programming mode
.
Previously set values can be overwritten.
A comprehensive description is to be found in Part 4:
Short Description Microcontrol.
Press the "
P
" key.
The programming mode is exited; the sewing unit is operational.
–
Setting the seam length.
Press the
" L1 "
or
" L2 "
or
" L3 " key
.
Set the desired value with the
" + "
or
" - "
keys.
Establishing the seam length via the transmitted light barrier.
Press the key.
–
Press the "
Σ
" key.
The piece counter is reset to
0000
.
P10 L3 = 102
<--- REF --->
20