Operation Manual

2.12 Changing the Form Set

A form set corresponding to the desired seam form must be inserted.

Form set 0793 078001 = Straight seam

Form set 0793 078002 = Curved seam

Form set 0793 078034 = Curved seam for pleats

Form set 0793 078xxx = Customer-specific version

Caution Risk of Injury !

Turn the main switch off.

The form set may only be changed with the sewing unit turned off.

Taking the form set out

–

Turn the handwheel until the needle lies in the 2nd position

(OT)

–

Push the form set into the left end position.

–

Turn handle 1 approx. 90° counterclockwise.

–

Lift the form set 2 on the left side and carefully loosen from the

transport carriage.

–

Remove the form set.

Inserting the form set

–

Turn the handwheel until the needle lies in the 2nd position

(OT)

–

Push the transport carriage into the left end position.

–

Carefully place the right side of form set 2 onto the transport

carriage.

–

Turn handle 1 approx. 90° counterclockwise and place the form set

completely on the the transport carriage.

–

Turn handle 1 back.

The form set is locked and sits firmly on the transport carriage.

–

Position the press-on cylinder 4 with the guide roller on the guide

curve 3.

–

Push the form set to the right stop.