Operation Manual

2.7 Winding the Underthread

Caution Risk of Injury !

Turn the main switch off.

Thread the underthread for winding only with the sewing unit

turned off.

–

For a secure functioning of the remaining thread monitor remove

thread residue from the bobbin hub before winding.

–

Thread the underthread as shown in the illustrations.

–

Wind the underthread clockwise in the reserve groove 6 of the

bobbin hub.

–

Place the bobbin on the bobbin winder shaft 2.

–

Pull the thread end through the cutting clamp 3 and cut off.

–

Swing the bobbin winder flap 4 against the bobbin.

–

Set the bobbin thread tension 1.

The underthread should be wound with the least possible tension.

–

Turn the main switch on.

–

Start the sewing sequence.

–

The bobbin winder turns itself off after reaching the set bobbin fill

capacity.

For setting the bobbin fill capacity see the Service Instructions.

1 2 3