Operation Manual

14
3.7 Changing the hook-thread bobbin
Fig. 9
Remove the empty bobbin.
– Set the needle bar at an elevated position.
– Lift the bobbin case flap 2.
– Remove the bobbin case 3 with bobbin 6.
– Remove the empty bobbin from the bobbin case 3.
Insert a full bobbin.
– Insert a
full bobbin into the bobbin case 3.
– Observe the direction of rotation of the bobbin.
– The direction of rotation is correct when the bobbin rotates in an
opposite direction to the drawing direction of the thread.
– Pull the hook thread through the slit 5 underneath the tension
spring 4 into the hole 7.
– Pull approx. 5 cm of hook thread from the bobbin case 3.
– When pulling the thread, the bobbin should turn into the direction
indicated by the arrow.
– Reinsert the bobbin case 3.
– Close the bobbin case flap 2.
Caution: Risk of injury!
Switch off the main switch.
The hook-thread bobbin may only be changed with the machine switched
off.
CAUTION: Risk of breakage!
Press down firmly on the bobbin case and make sure it engages correctly.
2
1
3
4
5
6
7
2