Operation Manual

Operating Instructions 650-10 - 02.0 - 10/2015 97
Fig. 66: Length correction (2)
4. Do the same with all further sewing steps.
5. After the last sewing step tap the END button.
 This closes the length correction, and the operating
mode
EDIT ( p. 80) opens.
6.6 Displaying the software version
To display the software version:
1. Switch on and off the machine.
 The following appears on the display:
• On the left, the class
• On the right, the firmware
 The machine performs a reference run.
 The controller starts in the operating mode that was active
when it was switched off - MAN or AUTO.
6.7 Operating mode SERVICE
More information on the contents of Service mode can be found
in the  Service Instructions.