Operation Manual

Operating Instructions 650-10 - 02.0 - 10/201590
Parameters that can be set
The following table describes the parameters that can be set on
the PROGRAMMING user interface.
Symbol/button Meaning
Input the program name
There is only one display under
PROGRAMMING.
A new sewing program
is automatically assigned the next free
program
slot.
Select the right or left piece to be sewn
Set the sewing material size,  p. 91
Other program parameters under
PROGRAMMING,
 p. 93
Set the fullness in the current sewing step,
 p. 92
Set the curve support in the current sewing
step
Set the needle thread tension in the current
sewing step
Set the stitch length in mm in the current
sewing step
Switch the seam length measurement in
the current sewing step on or off
Other sewing step parameters under
PROGRAMMING,
 p. 94