Operation Manual

Operating Instructions 650-10 - 02.0 - 10/201588
 The second sewing step is displayed with its number in the
left pane.
Fig. 59: Creating a new sewing program (2)
6. Repeat sewing step 2 until all the sewing steps have been
programmed.
7. Tap the END button or cut the threads.
 There are 3 variants for the sewing program response -
depending on the user's input method:
8. If the threads were not cut after sewing, the message Cut off
thread appears.
 The message is cleared, and the following selection window
appears:
Variant Program display
The last programmed sewing step was sewn
but not cut off, then ended with END.
continue with step 8
The last programmed sewing step was sewn
and threads cut off.
continue with step 9
All sewing steps were input manually and
ended with END.
continue with step 9