Operation Manual

Operating Instructions 650-10 - 02.0 - 10/2015 85
To set the fullness:
1. Select the type of fullness.
 The type of fullness selected is displayed in an activated
control field within the symbol.
2. If a higher or lower degree of fullness is required, use the arrow
keys to display more buttons.
3. Input the fullness using the buttons 0 to 16.
EDIT mode Other program parameters
A tap on the Other program parameters button will bring up an
overview of all parameters available in
EDIT operating mode.
Fig. 56: Other program parameters
Parameters Meaning
Backtack at Start Bartack at seam beginning
Value range: 1 (= on) or 0 (= off)
Backtack at End Bartack at seam end
Value range: 1 (= on) or 0 (= off)
Thread Trimmer Thread trimmer
Value range: 1 (= on) or 0 (= off)