Operation Manual

Operating Instructions 650-10 - 02.0 - 10/201576
AUTO mode Temporarily correcting the fullness value until the next
sewing step
Fig. 49: Temporarily correcting the fullness value
Buttons for manually inputting the fullness are displayed in the left
pane.
To set the fullness:
1. Select the type of fullness.
 The type of fullness selected is displayed in an activated
control field within the symbol.
Symbol/button Meaning
Input the fullness.
The fullness setting is displayed by a
button
highlighted in red.
Select the type of fullness:
• Upper (upper transport)
• Lower (lower transport)
The fullness selected is displayed in an
activated control field.
Display of further buttons for inputting the
fullness. The buttons 0 to 16 are available
for input.