Operation Manual

Operating Instructions 650-10 - 02.0 - 10/201574
To set a parameter:
1. Tap the desired button.
 The user interface for setting the desired parameter is
displayed.
For some parameters the setting is more than just a numerical
value. These more complex parameters are described in detail
below.
AUTO mode Selecting the sewing program
Fig. 47: Selecting the sewing program
Proceed as follows to select a sewing program:
1. Tap the desired sewing program.
 The selected sewing program is displayed in an activated
control field within the line.
2. Tap the OK button.
 The selected sewing program is loaded in AUTO operating
mode.
You can tap the Abort button to cancel the selection of the program.
 If necessary the selected sewing program is discarded, and
the user interface for AUTO operating mode is displayed.