Operation Manual

Operating Instructions 650-10 - 02.0 - 10/2015 71
6.3.2 Sewing process
This is how you sew without fullness:
1. Set all fullness values to 0 ( p. 68).
2. Input the values for needle thread tension and stitch length.
3. Press the pedal forwards and sew.
 The length in mm sewn in the seam is displayed.
When the thread is cut, the display is reset.
This is how you sew with fullness:
1. Change the desired fullness ( p. 68).
2. Push the pedal forwards and sew.
 The length in mm sewn in the seam is displayed.
When the thread is cut, the display is reset.
You can also change parameters while in the middle of a seam.
This is how you change parameters in the middle of a seam:
1. Press foot pedal to position 0.
2. Change the desired parameter on the control panel
(( p. 68)).
3. Press the pedal forwards again and sew.
 The seam will be sewn using the altered parameter value.
Backtack at Start Bartack at seam beginning
Value range: 1 (= on) or 0 (= off)
Backtack at End Bartack at seam end
Value range: 1 (= on) or 0 (= off)
Thread Trimmer Thread trimmer
Value range: 1 (= on) or 0 (= off)
Parameters Meaning