Operation Manual

Operating Instructions 650-10 - 02.0 - 10/201556
Fig. 33: Creating a new sewing program (3)
The rest of the procedure is described in  5.5 Easy mode, p. 47.
6. Select whether progression to the individual steps to be pro-
grammed should be by using the knee lever or by automatic
progression.
7. Press the key.
Once the creation of the program is complete and the S key has
been pressed or after the thread cutoff has been entered, the
following selection window appears:
Fig. 34: Creating a new sewing program, selection window
8. Press the corresponding key to select if
• the sleeve side that was programmed should be mirrored
• the sleeve side that was programmed should not be
mirrored
• the teach-in for the 2
nd
sleeve side should be opened
5.6.3 Copying the sewing program
The selected sewing program is copied into a new program
number.
Proceed as follows to copy an existing sewing program:
1. Press the key.
 The softkey menu appears on the display: