Operation Manual

Operating Instructions 650-10 - 02.0 - 10/2015 51
1. Insert the sewing material.
2. Input the parameters for the 1
st
step (fullness, stitch length,
thread tension and curve support).
3. Sew the first step.
4. Operate the knee lever.
 The controller switches to the next step.
Once all steps are complete:
5. Press the S key.
 The sewing program is saved.
The following appears on the display:
Fig. 27: Creating a program by sewing the seam (1)
6. Sew the overlap.
7. Press the foot pedal fully back.
 The sleeve that was created is mirrored, depending on the
settings at the technician level.
The controller switches to Automatic mode.
The sewing program that was just created is activated.
Fig. 28: Creating a program by sewing the seam (2)
5.6 Edit mode
Prerequisite: You are in Automatic mode ( p. 43).
5.6.1 Edit the sewing program
1. In Automatic mode, press the P key.
 The controller switches to Edit mode.