Operation Manual

Operating Instructions 650-10 - 02.0 - 10/201550
5.5.1 Creating a program by keyboard input
Information
Before the S key is pressed, program creation can be canceled
at any time by pressing the ESC key.
1. Set all the parameters for each step.
2. Operate the knee lever.
 The controller switches to the next step.
Once all steps are complete:
3. Press the S key.
 The sewing program is saved.
Depending on the settings at the technician level
• The sleeve side that was created is mirrored
• The sleeve side that was created is not mirrored
• The teach-in for the 2
nd
sleeve side is opened
• The selection screen for the action of creating the
2
nd
sleeve side is opened
 The controller switches to Automatic mode.
The sewing program that was just created is activated.
Fig. 26: Creating a program by keyboard input
5.5.2 Creating a program by sewing the seam
Information
Before the S key is pressed, program creation can be canceled
at any time by pressing the
ESC key.
If a section of seam has already been sewn the sewing program
will have been saved and must if necessary be deleted,
( p. 58).