Operation Manual

Operating Instructions 650-10 - 02.0 - 10/201546
The parameter values for the current step are shown on the
display.
The program bar (1) shows the progress of the seam.
The number (2) under the current step (3) shows the outstanding
length of the step.
The program bar shows half the current step in bold.
Fig. 21: Sewing process, current step
Completed steps are shown fully in bold.
Fig. 22: Sewing process, completed step
The following table lists the functions that can be performed in the
course of the seam.
Key/Pedal Function
Plus/minus
and
0 – 16
Temporary correction of the fullness value
(valid only for the current step)
Additional
pedal
(optional)
Temporary correction of the fullness value or
the
curve support (depending on the setting in the
technician
level)
(valid only for the current step)
Knee lever Next program step
/
3
Stop forward/back or to the start of the step
Switch the sleeve side (if programmed) in the 1
st
step
at the start of the step
/
Correction of the thread tension
The value is saved
P, F, S, OK No function assigned