Operation Manual

Operating Instructions 650-10 - 02.0 - 10/2015 131
2180 Error Direction of rotation • Replace the encoder
• Check plug assignment and
change, if necessary
• Check wiring in machine
distributor and change it,
if
necessary
• Test stepper motor phases
and check for correct value
2181 Error Error in the reference run • Replace the reference
switch
2182 Error Stepper motor current error • Remove the blockage
• Check the encoder cable
and replace, if necessary
• Replace the stepper motor
2183 Error Stepper motor overcurrent • Replace the sewing motor
cable
• Replace the stepper motor
• Replace the control
2184 Error Software error • Perform reset
• Perform a software update
• Contact customer service
2185 Error Stepper motor insulation
error
• Check motor phase and
PE
for low-impedance
connection
• Replace the encoder
• Replace the stepper motor
2186 Error Software error • Perform reset
• Perform a software update
• Contact customer service
2187 Error Software error • Perform reset
• Perform a software update
• Contact customer service
2188 Error Software error • Perform reset
• Perform a software update
• Contact customer service
Code Type Possible causes Remedial action