Operation Manual

Operating Instructions 650-10 - 02.0 - 10/2015 127
1006 Error Sewing motor error:
• Max. speed exceeded
• Sewing motor cable
defective
• Sewing motor defective
• Switch the machine off and
on again
• Replace the encoder
• Perform reset
• Replace the sewing motor
• Contact customer service
1007 Error Error in the reference run • Replace the encoder
• Eliminate stiff movement in
the machine
1008 Error Sewing motor encoder error • Replace the encoder
1010 Error Sewing motor synchroniza-
tion error:
• External synchronizer
plug
(Sub-D, 9-pin) not
connected
• Connect plug of external
synchronizer to controller,
use correct connection
(Sync)
• Replace the reference
switch or synchronizer
• Only required for machines
with transmission!
1011 Error Sewing motor synchroniza-
tion error (Z pulse)
• Switch off the controller,
use handwheel to turn and
switch on the controller
again
• If error is not corrected,
check encoder
1012 Error Sewing motor synchroniza-
tion error
• Replace the synchronizer
1051 Error Sewing motor timeout:
• Cable to sewing motor
Reference switch defective
• Reference switch defective
• Replace the cable
• Replace the reference
switch
1052 Error Sewing motor overcurrent:
• Sewing motor cable
defective
• Sewing motor defective
• Controller defective
• Replace the sewing motor
cable
• Replace the sewing motor
• Replace the control
1053 Error Sewing motor overvoltage • Check the mains voltage
1054 Error Internal short circuit • Replace the control
Code Type Possible causes Remedial action