Operation Manual

Operating Instructions 650-10 - 02.0 - 10/2015118
OP7000 control panel
Fig. 81: Connecting the OP7000 control panel
Connect the OP7000 as follows:
1. Tighten the control panel (8) to the bracket (7) and align it.
2. Insert the plug for the cable (6) at the control panel, guide it
through the opening in the tabletop
(5) to the controller, and
connect it to the socket (X170b).
8.10 Carrying out a test run
Perform a test run when setup is complete.
To perform a test run:
1. Insert the power plug.
2. Wind on the hook thread ( p. 25).
⑧⑦⑥⑤
(5) - Tabletop opening
(6) - Cable
(7) - Holder
(8) - Control panel
WARNING
Risk of injury from sharp parts!
Punctures possible.
Switch off the machine before threading the
needle or hook thread.