Operation Manual

Operating Instructions 650-10 - 02.0 - 10/2015110
8.6 Completing the tabletop
Fig. 73: Completing the tabletop
To complete the tabletop:
1. Insert the oblique fittings (4).
2. Insert the rubber corners (5) into the tabletop.
3. Using 4.5 x 15 (4x) screws, tighten the hinge mountings (2).
4. Using 4.5 x 55 (8x) screws, screw the edge strips (3) to the
tabletop.
5. Insert the machine head support (1).
8.7 Setting the working height
The working height can be adjusted between 780 and 900 mm
(measured to the upper edge of the tabletop).
(1) - Machine head support
(2) - Hinge mountings
(3) - Edge strips
(4) - Oblique fittings
(5) - Rubber corners
①
⑤
④
②
③
NOTICE
Property damage due to a lack of care!
Possible damage to setpoint device.
Before setting the working height, loosen the screws on the
foot pedal rods of the setpoint device.