Operation Manual

Operating Instructions 650-10 - 02.0 - 10/2015 109
Attach the tabletop and the pedals to the stand as follows:
1. Using wood screws (6 x 30), attach the stand (2) to the
tabletop (1). Drill pilot holes for the wood screws.
2. Observe the center marks for the stand.
3. Turn the stand (2) the right way up.
4. Align the pedals.
5. For ergonomic reasons, align the pedals laterally so that the
center of the main pedal
(4) is directly beneath the needle.
The stand strut (5) is provided with slotted holes to allow
alignment of the pedal.
6. Loosen the screws (3).
7. Adjust the height of the foot pedal rods so that in the home
position the pedal slope is about 10°.
8. Tighten the screws (3).
9. Insert the thread reel holder (6) into the hole in the tabletop (1)
and secure it with a nut and washer.
10. Align thread reel holder and thread guide.
Important
The thread guide must be positioned vertically above the
thread reel holder.