Operation Manual

Operating Instructions 650-10 - 02.0 - 10/2015 107
5. Turn the adjusting screw (3) to ensure that the stand is posi-
tioned securely. All 4 feet of the stand must be in contact with
the floor.
8.4 Pre-assembling the tabletop
Fig. 71: Pre-assembling the tabletop
To pre-assemble the tabletop:
1. Turn the tabletop over so that its bottom side is facing up.
2. Tighten the controller at (2) (chipboard screws 5 x 30).
3. Use screws to tighten the permanent magnets of the tilt sensor (8)
for the machine head (accessory pack) on the underside of the
tabletop.
4. Tighten the drawer and its brackets at (9)
(chipboard screws 3.5 x 17).
(1) - Stand
(2) - Controller
(3) - Knee lever
(4) - Strain relief mechanism
(5) - Setpoint device for additional
pedal
(6) - Cable duct
(7) - Setpoint device for main pedal
(8) - Tilt sensor
(9) - Drawer
④③②
⑥⑤①⑦⑨⑧