Operation Manual

Operating Instructions 650-10 - 02.0 - 10/2015106
8.2 Removing the transport locks
When you have installed the machine which you bought, you must
remove the following transport locks:
• Lashing straps and wooden blocks from the machine head,
the tabletop and the stand
• Restrain block and lashing straps from the sewing drive
8.3 Assembling the stand
Fig. 70: Assembling the stand
Fit the stand as follows:
1. Attach the main pedal (1) to the cross strut (2).
2. Attach the additional pedal (optional) to the cross strut (2).
3. Attach the cross strut (2) to the stand.
4. After the machine has been fully assembled, align the pedals
( p. 108).
(1) - Main pedal
(2) - Cross strut
(3) - Adjusting screw (covered)
① ②
③