Operating instructions

5. Aligning the needle bar parallel to the looper turret

Caution: Danger of injury!

Switchthemainswitchoff.

Adjust the needle bar only with the main switch switched off.

Standard checking

The needle bar 1 and the looper turret 3 must be in parallel position.

–

Remove the cutting block.

–

Unscrew the finger protection and the head cover.

Note !

Do not separate the cable from the head cover.

–

Switch the machine on.

The machine runs to its initial position.

–

Switch the machine off.

–

Stake out the looper turret with arresting pin 2.

–

Position an angle 5 at the right side 6 of the looper turret.

–

Check whether the screw 7 at the needle bar guide 8 abuts on the

angle.

Correction

–

Loosen the screws 9 at the toothed belt wheel 10.

–

Turn the needle bar guide 4 correspondingly.

–

Tighten the screws 9 at the toothed belt wheel 10.

–

Switch the machine on.

–

Check the needle bar position.