Operation Manual

Maintenance
Operating Instructions 610-10/630-10 - 00.0 - 01/201684
Maintenance interval
6.1 Cleaning
Work to be carried out Operating hours
8 40 160 500
Machine head
Removing lint and thread remnants 
Remove any lint in the area below the throat
plate

Check oil level at machine head 
Check oil level at looper drive housing 
Pneumatic system
Checking the operating pressure 
Check the water level in the pressure controller 
Clean the filter element in the maintenance unit 
Check the tightness of the system 
WARNING
Risk of injury from flyin
g particles!
Flying particles can enter the eyes, causing
injury.
Wear safety goggles.
Hold the compressed air gun so that the particles
d
o not fly close to people.
Make sure no particles fly into the oil sump.