Operation Manual

Settings via software
Operating Instructions 610-10/630-10 - 00.0 - 01/2016 81
Fig. 48: Length correction (2)
4. Do the same with all further sewing steps.
5. After the last sewing step tap the END bu
tton.
 Thi
s closes the length correction, and the operating
mode EDIT ( p. 63) opens.
5.6 Displaying software version
To display the software version:
1. Switch the machine off and on ( p. 20).
 The
following appears on the display:
• On the left, the class
• On the right, the firmware
 The
machine performs a reference run.
 The
controller starts in the operating mode that was active
when it was switched off - MAN or AUTO.
5.7 Operating mode SERVICE
More information on the contents of Service mode can be found
in the  Service Instructions.