Operation Manual

Settings via software
Operating Instructions 610-10/630-10 - 00.0 - 01/201672
9. When all sewing steps have been programmed, tap the END
button or cut off the thread.
 The
re are 3 variants for the sewing program response -
depending on the user's input method:
10. If the thread was not cut after sewing, the message Cut off
thread appears.
 The
message is cleared, and the following selection window
appears:
Fig. 42: Creating a new sewing program, selection window
Variant Program display
The last programmed sewing step was sewn,
but threa
d was not cut off, and program was
ended with
END.
Continue with 10.
The last programmed sewing step was sewn,
and threa
d was cut off.
Continue with 11.
All sewing steps were input manually and
ended with END.
Continue with 11.