Operation Manual

Settings via software
Operating Instructions 610-10/630-10 - 00.0 - 01/2016 71
Important
In the 1
st
sewing step, it is not possible to feed any tape.
This is why the buttons will not be displayed until the 2
nd
sewing step.
Information
All entries only refer to the corresponding sewing step.
6. Sew the 1
st
sewing step, or manually input the length of the
sewing step using the seam length measurement parameter.
7. Select the next sewing step by tapping the number of the 1
st
sewing step or by pressing the Knee button.
 The
left pane displays the 2
nd
sewing step with its number.
Fig. 41: Creating a new sewing program (2)
8. Repeat sewing step 2 until all the sewing steps have been
programmed.