Operation Manual

Settings via software
Operating Instructions 610-10/630-10 - 00.0 - 01/2016 53
5.3.2 Sewing process
This is how you sew without fullness:
1. Set all fullness values to 0 ( p. 50).
2. Adopt or, if necessary, enter the values for needle thread
ten
sion and stitch length.
3. Press the pedal forward and sew.
 The
length in mm sewn in the seam is displayed.
When the thread is cut, the display is reset. When starting
the
next sewing process, the machine will start counting at 0.
This is how you sew with fullness:
1. Set the desired fullness ( p. 50).
2. Press the pedal forward and sew.
 The
length in mm sewn in the seam is displayed.
When the thread is cut, the display is reset. When starting
the
next sewing process, the machine will start counting at 0.
You can also change parameters while in the middle of a seam.
This is how you change parameters in the middle of a seam:
1. Press the pedal to position 0.
2. Change the desired parameter on the control panel ( p. 50).
3. Press the pedal forward again and sew.
 The
seam will be sewn using the altered parameter value.
Thread Tension at Hook Looper thread tension 1 – 99
Adjust Bottom Fullness
in %
Fullness correction
pa
rameter bottom (%)
-50 – 50
Adjust Flat Sewing in % Flat sewing correction,
only when sewing without
full
ness (%)
0 –
50
Parameter Meaning Value range