Operation Manual

Settings via software
Operating Instructions 610-10/630-10 - 00.0 - 01/2016 51
Mode MAN Setting the fullness
The following table lists the individual symbols and buttons for
man
ually setting the fullness.
To set the fullness:
1. Select the type of fullness.
 The
type of fullness selected is displayed in an activated
control field within the symbol.
2. If a higher or lower degree of fullness is required, use the
arrows to
display more buttons.
3. Input the fullness using the buttons 0 to 16.
Mode MAN Other program parameters
A tap on the Other progra
m parameters button will bring up an
overview of all available parameters.
Symbols/buttons Meaning
Input the fullness.
The fullness setting is displayed by a
button highlighted in red.
Select the type of fullness:
• Top (top feed)
• Lower (lower transport)
• Top and bottom (differential top and
b
ottom feed)
The fullness selected is displayed in an
activated contr
ol field.
Display of further buttons for inputting the
fullness. The b
uttons 0 to 16 are available
for input.