Operation Manual

Operation
Operating Instructions 610-10/630-10 - 00.0 - 01/201630
Fig. 13: Threading the reinforcement tape (3)
6. Activate threading mode by pressing the two push buttons (9)
on the machine at the same time.
 The
tape clamp is released, making compressed air avail-
able in the guide piece (10) for the transport of the reinforce-
ment tape.
7. Insert the reinforcement tape through the guide (12).
8. Set the guide (12) approximately to the width of the reinforce-
ment tape used.
9. Insert the reinforcement tape through the tape clamp (11).
10. Insert the reinforcement tape into the guide piece (10) and
allo
w it to run through until no excess reinforcement tape is
left between the tape clamp (11) and the guide piece (10).
Grab the reinforcement tape, using, for exa
mple, a pair of twee-
zers while holding on to the end.
(9) - Push buttons
(10) - Guide piece
(11) - Tape clamp
(12) - Guide
⑩
⑪
⑫
⑨