Operation Manual

Operation
Operating Instructions 610-10/630-10 - 00.0 - 01/201624
Fig. 5: Threading the needle thread (2)
3. Feed the thread from top to bottom through the thread
guide (10).
4. Feed the thread to the rear side
of the thread guide (10) before
threading it from rear to front through the lower hole.
5. Feed the thread from top to botto
m through the thread guide
(9) on the needle thread tensioner element (8).
6. Feed the thread clockwise around the needle thread tensioner
elemen
t (8).
Important
The thread must always be fed around the appropriate ten-
sion disk in such a way that it follows the longer path from
thre
ad guide (9) to thread guide (7).
7. Insert the thread through the thread guide (7).
8. Insert the thread from the right to the left through the thread
advan
cing device (11).
9. Feed the thread from the right to
the left through the diverter (3).
10. Feed the thread from right to left through the thread
re
gulator (4) and the thread lever (5):
(3) - Diverter
(4) - Thread regulator
(5) - Thread lever
(6) - Thread guide
(7) - Thread guide
(8) - Needle thread tensioner element
(9) - Thread guide
(10)- Thread guide
(11)- Thread advancing device
③
④
⑤
⑥
⑨
⑦
⑧
⑩⑪