Operation Manual

Troubleshooting
Operating Instructions 610-10/630-10 - 00.0 - 01/2016 131
6361 Warning Machine ID not connected • Check the connection of the
machine ID cable
• Replace the machine ID
• Replace the controller
6400
–
6999
Error Internal error • Switch the machine off and on
aga
in
• Performing a software update
• Contact Customer Service
7551
–
7659
Error • Internal error
• Cable disturbance
• Cables to the control panel
Interface defective
• Switch the machine off and on
aga
in
• Eliminate source of disturbance
• Performing a software update
• Replace the cable
• Contact customer service
9310 Error • CAN connector not plugged in
or
faulty
• Tape unwinder faulty
• Replace the CAN connector
• Replace the tape unwinder
• Replace the controller
9320 Error • Tape unwinder dirty
• Tape unwinder faulty
• Clean the tape unwinder
( p. 90)
• Open the throttle ( p. 79)
• Replace the tape unwinder
9910 Error Tilt sensor:
• Machine head is tilted over
• Tilt sensor not assembled or
de
fective
• Erecting the machine head
• Fit or replace tilt sensor
Code Type Possible causes Remedial action