Operation Manual

Troubleshooting
Operating Instructions 610-10/630-10 - 00.0 - 01/2016 129
2480 Error Direction of rotation • Replace the encoder
• Check plug assignment and
change, if necessar
y
• Check wiring in machine distribu-
tor and change it, if necessary
• Test stepper motor phases and
c
heck for correct value
2481 Error Error in the reference run • Replace the reference switch
2482 Error Stepper motor current error • Remove the blockage
• Check the encoder cable and
r
eplace, if necessary
• Replace the stepper motor
2483 Error Stepper motor overcurrent • Replace the sewing motor cable
• Replace the stepper motor
• Replace the controller
2484 Error Software error • Perform reset
• Performing a software update
• Contact Customer Service
2485 Error Stepper motor insulation error • Check motor phase and PE for
low-
impedance connection
• Replace the encoder
• Replace the stepper motor
2486 Error Software error • Perform reset
• Performing a software update
• Contact Customer Service
2487 Error Software error • Perform reset
• Performing a software update
• Contact Customer Service
2488 Error Software error • Perform reset
• Performing a software update
• Contact Customer Service
2901 Error Referencing timeout • Switch the machine off and on
aga
in
• Check the clamping of the
stepper motor
3010 Error Controller: 100 V voltage error • Check the connections
• Replace the controller
Code Type Possible causes Remedial action