Operation Manual

Troubleshooting
Operating Instructions 610-10/630-10 - 00.0 - 01/2016120
2174 Error Software error • Perform reset
• Performing a software update
• Contact Customer Service
2175 Error Magnet wheel search • Check the connection
• Test stepper motor phases
(R = 2.8Ω, high impe
dance to
PE)
• Replace the encoder
• Replace the stepper motor
• Replace the controller
2177 Error Stepper motor overload (I²T) • Remove the cause of the stiff
movement o
r blockage
• Replace the stepper motor
• Replace the controller
2178 Error Encoder error • Check the connection of the
encoder
cable and replace, if
necessary
• Replace the controller
2179 Error Current sensor:
• Stepper motor card defective
• Controller defective
• Replace the controller
2180 Error Direction of rotation • Replace the encoder
• Check plug assignment and
change, if necessar
y
• Check wiring in machine distribu-
tor and change it, if necessary
• Test stepper motor phases and
c
heck for correct value
2181 Error Error in the reference run • Replace the reference switch
2182 Error Stepper motor current error • Remove the blockage
• Check the encoder cable and
r
eplace, if necessary
• Replace the stepper motor
2183 Error Stepper motor overcurrent • Replace the sewing motor cable
• Replace the stepper motor
• Replace the controller
2184 Error Software error • Perform reset
• Performing a software update
• Contact Customer Service
Code Type Possible causes Remedial action