Operation Manual

Troubleshooting
Operating Instructions 610-10/630-10 - 00.0 - 01/2016 117
1008 Error Sewing motor encoder error • Replace the encoder
1010 Error Sewing motor synchronization
err
or:
• External synchronizer plug
(
Sub-D, 9-pin) not connected
• Connect plug of external
s
ynchronizer to controller,
use correct connection (Sync)
• Replace the reference switch or
s
ynchronizer
• Only required for machines with
tr
ansmission!
1011 Error Sewing motor synchronization
err
or (Z pulse)
• Switch off the controller, use
handwheel to turn and switch on
the controller again
• If error is not corrected, check
encoder
1012 Error Sewing motor synchronization
err
or
• Replace the synchronizer
1051 Error Sewing motor timeout:
• Cable to sewing motor
Reference switch defective
• Reference switch defective
• Replace the cable
• Replace the reference switch
1052 Error Sewing motor overcurrent:
• Sewing motor cable defective
• Sewing motor defective
• Controller defective
• Replace the sewing motor cable
• Replace the sewing motor
• Replace the controller
1053 Error Sewing motor overvoltage
• Check the mains voltage
1054 Error Internal short circuit • Replace the controller
1055 Error Sewing motor overload (I²T):
• Sewing motor not moving freely
or blocked
• Sewing motor defective
• Controller defective
• Remove the cause of the stiff
movement o
r blockage
• Replace the sewing motor
• Replace the controller
1056 Error Sewing motor overtemperature:
• Sewing motor not moving freely
• Sewing motor defective
• Controller defective
• Correct the cause of not moving
fr
eely
• Replace the sewing motor
• Replace the controller
1058 Error Sewing motor speed greater
than setpoint:
• Reference switch defective
• Sewing motor defective
• Replace the reference switch
• Replace the sewing motor
Code Type Possible causes Remedial action