Operation Manual

Setup

Operating Instructions 610-10/630-10 - 00.0 - 01/2016102

Fig. 60: Adjusting the pedal

Inclination of the pedal

The pedal (2) should be tilted to a degree that allows the operator

to move th

e pedal forward and backward without a problem.

You set the inclination of the pedal as follows:

1. Loosen the screw (3).

2. Adjust pedal (2) accordingly.

3. Re-tighten the screw (3).

Position of the pedal

The pedal (2) is attached to the cross strut of the stand. You can

djust the position of the pedal individually by shifting the position

of the cross strut.

You set the position of the pedal as follows:

1. Loosen the screw with wing nut (1) on both si

des of the stand.

2. Slide the cross strut that holds the pedal (2) forward or

backward

3. Tighten the screw with wing nut

(1) on both sides of the stand.

(1) - Wing nut

(2) - Pedal

(3) - Screw

③

②

①