Operation Manual

Setup
Operating Instructions 610-10/630-10 - 00.0 - 01/2016 101
Fig. 59: Setting the working height
To set the working height:
1. Loosen the screws (1) on both stand bars.
2. To avoid jamming, slide the tabletop
in or out evenly at both
sides.
The scales on the outer sides of the stand bars serve as an
adju
stment aid.
3. Tighten the screw (1) on both bars of the stand.
7.6 Adjusting the pedal
(1) - Screw
①
NOTICE
Property damage from incorrect setting!
If done carelessly, adjus
ting the settings separately can
cause damage to the machine.
Always adjust the inclination and position of the pedal as a
fun
ction of one another.