Operation Manual

Settings via software
Operating Instructions 610-01/630-01 - 02.0 - 08/2015 95
9. If the thread was not cut after sewing, this message appears:
Cut thread.
 The message disappears and the selection window appears.
Fig. 51: Selection after programming
10. Select whether the new seam program is to be mirrored for
the other side of the sewing material (Mirror programmed side
to other side), programmed for the other side of the sewing
material (Program other side) or whether the programming
is to be ended (Finish).
11. Select the desired function.
 The selected function is represented by an activated
co
ntrol field.
12. Press the OK b
utton.
 Seam program is saved. Depending on the selected
fun
ction, you are presented with different interfaces: