Operation Manual

Settings via software
Operating Instructions 610-01/630-01 - 02.0 - 08/201594
All inputs refer only to the relevant segment.
5. Sew the first segment or input the length of the segment
by hand via the path measurement parameter.
6. Choose the next segment by pressing on the number
of the first segment or the knee switch.
 In the area on the left, the second segment with number
is shown.
Fig. 50: Programming mode PROGRAMMING continued
7. Repeat step 2, until all segments are programmed.
8. When all segments are programmed, press button END
or cut thread.
 There are three variants in terms of how the program reacts
–
depending in the input method used by the operator:
Variant Program display
The last programmed segment was sewn,
but not cut, then ended with END.
continue with step 9
The last programmed segment was sewn
and cut.
continue with step 10
All segments were input manually and ended
with END.
continue with step 10