Operation Manual

Settings via software
Operating Instructions 610-01/630-01 - 02.0 - 08/2015 83
1. Select type of fullness.
 The selected type is displayed by an activated control field
in the icon.
2. If a higher or lower fullness is required, display further buttons
using
the arrow buttons.
3. Input fullness with the buttons 0 to 16.
The fullness setting remains active until the next segment.
AUTO mode Correct fullness ratio
Fig. 41: Fullness correction in % parameter
1. Input the correction value for the fullness as a percentage.
Information on inputting numerical values:  pg. 69.
2. Press the OK b
utton.
 Correction value is saved and th
e preceding user interface
is displayed again.
If the new correction value is changed in automatic mode
AUTO, it remains active until the next time the program
is changed.