Operation Manual

Settings via software
Operating Instructions 610-01/630-01 - 02.0 - 08/2015 77
7.5.2 Sewing process
Sewing without fullness
1. Set all fullness values to 0 ( pg. 74).
2. Input values for needle t
hread tension and stitch length.
3. Press the foot pedal forwards and sew.
 The distance covered in mm is displayed. If the thread is cut,
the display is
reset.
Sewing with fullness
1. Change desired fullness ( pg. 74).
2. Press the foot pedal forwards and sew.
 The distance covered in mm is displayed. If the thread is cut,
the display is
reset.
Changing parameters during sewing
1. Bring the foot pedal to position 0.
2. Change desired parameters on the control panel ( pg. 74).
3. Press the foot pedal forwards again and sew.
 The changed parameter value is used.