Operation Manual

Settings via software
Operating Instructions 610-01/630-01 - 02.0 - 08/201576
MAN mode Other program parameters
After pressing the button Oth
er program parameters, an over-
view of all available parameters is displayed.
Fig. 36: Other program parameters in MAN mode
Parameter Meaning
Needle Stop Position Up When sewing stops the needle position
is up (activated) or down (not activated)
Stitch Condensing at Start Stitch condensing at start of sewing
on (activated) or off (not activated)
Stitch Condensing at End Stitch condensing at end of sewing
on (activated) or off (not activated)
Thread Trim Thread cutter on/off.
Value range: 0, 1
Thread Tension at Hook Looper thread tension.
Value range: 0…99
Additional Fullness Additional fullness
Value range: -50…50 (%)