Operation Manual

About these operating instructions
Operating Instructions 610-01/630-01 - 02.0 - 08/2015 5
1.5 Liability
All information and notes in these operating instructions have been
compiled in accordance with the latest technology and the appli-
cable standards and regulations.
The manufacturer cannot be held liable for any damage due to:
• Damage during transport
• Failure to observe the operating instructions
• Improper use
• Unauthorized modifications to the machine
• The deployment of untrained personnel
• Using unapproved spare parts
1.5.1 Transportation
Dürkopp Adler cannot be held liable for any damage during trans-
port. Check the delivered product immediately after receiving it.
Re
port any damage to the last transport manager. This also
applies if the packaging is not damaged.
Keep the machines, devices and packaging material in the
co
ndition they were in at the time when the damage was identified.
This secures any
claims towards the transport company.
Report all other complaints to Dürkopp Adler immediately after
re
ceiving the product.
1.5.2 Intended use
Sewing machine 610
The Dürkopp Adler 610 is for smooth sewing or incorporating
ful
lness into the upper and/or lower material layer.
This sewing machine is optimized with grading logic for the pro-
grammed pre-ruffing of sleeves (sleeve crown) and programmed
tap
ing of armholes, necklines etc. Sewing on tape requires
a needle strength of 70-130 Nm.
Sewing machine 630
The Dürkopp Adler 630 is for smooth sewing or incorporating
ful
lness into the upper and/or lower material layer.