Operation Manual

Operation
Operating Instructions 610-01/630-01 - 02.0 - 08/201540
the key panel (9).
The tape is cut at the bottom end of the guide piece (12).
Important
If the piece of tape cut off is too short, it can b
e pulled into the
bushing and prevent the feeding of the tape.
5.8.1 Feeding the tape
 7 Settings via software, pg. 67
5.9 Setting the sewing foot pressure
The adjusting wheel (1) and rotary button (2) on the machine head
are used to regulate the pressure of the sewing feet on the sewing
material. Here, the center foot and top feed foot can be adjusted
separately.
Correct setting
The sewing material does not slip and is fed through correctly.
T
he correct sewing foot pressure depends on the sewing material.
Faults due to incorrectly set sewing foot pressure
• Excessively high sewing foot pressure:
Indentations in the sewing material, possible ruffing of the
sewi
ng material.
• Excessively low sewing foot pressure:
Slipping of the sewing material, stitch length too short.